573102 | REV. A | 07.2015
Bosch Automotive Service Solutions Inc.
CP9680
AutoScanner® Plus
| User guide |
29
|
en
Select Module
OBDII/EOBD
Engine
ABS
Airbag
4. Observe “Command sent” message is displayed.
•
Press
.
Erase Codes
Press ENTER to continue
Command sent
Codes remaining:0
5. Return to
Diagnostic Codes Menu
.
•
Press
.
5.4
MIL Status
From
Special Tests Menu
:
1. Select
MIL Status
.
•
Use the
UP
and
DOWN
keys until
MIL
Status
is highlighted.
•
Press
.
Special Tests
I/M Monitors
Drive Cycle Monitor
State OBD Check
MIL Status
O2 Monitor Tests
Diagnostic Monitor Tests
On-Board Systems
Vehicle Information
Oil Light Reset
2. View
MIL Status
.
•
Press
to return to
Special Tests Menu
.
MIL is ON
Press ENTER to continue
MIL lamp should be ON if
engine is running
MIL is OFF
Press ENTER to continue
MIL lamp should be OFF
engine is running
5.5
State OBD Check
The
State OBD Check
function is used to display a basic
status of the vehicles OBD system.
•
Malfunction indicator lamp (MIL) status
•
Codes found
•
I/M monitors
Erase Codes
deletes DTCs and resets I/M monitors from
vehicle’s computer module(s).
The
State OBD Check
function has the following areas:
•
MIL Status ON or OFF
•
Number of Codes Found
•
Number of Monitors OK
•
Number of Monitors Inc
•
Number of Monitors N/A
State OBD Check
should be done with the key on
engine running (KOER) due to showing MIL status.
The number of codes found are only Global OBD II codes and
not pending codes.
The number of monitors that are either ok, inc, or na are
only Since DTCs Cleared and not This Drive Cycle.
Refer to
Read Codes
and
I/M Monitors
for more
detailed information about the results.
From
Special Tests Menu
:
1. Select
State OBD Check
.
•
Use the
UP
and
DOWN
keys until
State
OBD Check
is highlighted.
•
Press
.
Special Tests
I/M Monitors
Drive Cycle Monitor
State OBD Check
MIL Status
O2 Monitor Tests
Diagnostic Monitor Tests
On-Board Systems
Vehicle Information
Oil Light Reset
2. View
State OBD Check
display.
