Acclaim Lighting Ai Flex Interior, User Manual

Page: 24 / 40

22
www.acclaimlighting.com
Click
TO MOUNT A FLEX DUAL CHANNEL
1 Survey the mounting area and determine the entry point for the supply cabling and the
load bearing capacity/construction of the wall (i.e. drywall, brick, etc).
2 If necessary, cut the main channel, backplate and polycarbonate lenses to suit the
required length - all of these items should be exactly the same lengths.
3 Ensure that the supply cabling for the upper and lower Ai Flex
tape runs are brought through to the channel’s central
void ready for connection to the main incoming
connection. At least one hole per tape mounting
surface will need to be drilled through -
ensure all burrs are removed and for best
practise, fit suitable grommets to
guard against cable damage.
4 Once all tape connections
have been made and brought
through to the central void,
align the chamfered edges of each
Polycarbonate lens with the grooves
located on the upper and lower
surfaces of the channel. Slide
the lenses all of the way in
until their edges align with the
channel.
5 Drill a mounting hole at each end of the
Backplate (at a diameter to suit your chosen
fixing screws) and also a Ø0.71” (18mm) hole
that will align with the supply cabling.
6 Remove any burrs, insert the supplied
grommet into the larger hole and stick
the supplied spacers onto the rear of
the backplate, one each side of both
mounting holes.
7 Feed the supply cabling through the
grommet and secure the backplate to the
mounting surface.
8 Offer up the channel to the backplate and make the
necessary connections to the supply cabling within
the central void in the channel.
9 Once all connections are tested, incline the channel
back slightly along its axis and engage the upper
slot (at the rear) of the channel with the top surface
of the backplate. Rotate the channel down so that its
lower slot engages with the bottom surface of the
backplate - you should hear a ‘click’ as the two items
fully lock together.
+24V
W1
W2
W3
W4
+24V
W1
W2
W3
W4
+24V
W1
W2
W3
W4