Acclaim Lighting Ai Flex Interior, User Manual

Page: 13 / 40

11
www.acclaimlighting.com
+24
V
W1
W2
W3
W4
10mm
TO FIT THE AI FLEX TAPE
1 If necessary, cut the channel to the length required. Ensure that any resulting burrs are
removed.
2 Ensure the tape mounting surface within the channel is completely dry, clean and free of
grease. If cleaning is required, please see page 4 for details.
3 Determine the length of tape required. Leave at least a 10mm gap at each
end to allow the end caps to be inserted. Mark the positions at each
end of the channel where the tape will be placed.
Note: Ai Flex tape can only be cut every 6.5” (166mm), which
may constrain the precise lengths of tape that can be
achieved. Therefore it may be beneficial to center the tape
within the channel to achieve an even distribution.
4 Cut the tape to the nearest marked cutpoint.
5 Begin peeling the backing from the Ai Flex
tape and carefully stick the Ai Flex tape into the
channel, starting at the marked position.
IMPORTANT: While pressing the Ai Flex tape into position, take care not to put
excessive pressure on the components or connections.
FLEX PENDANT CHANNEL (FLK PEN)
The Flex pendant channel can be mounted from fixed steel rods, stainless wire or against a
flat surface. Clear, opal and frosted lens options are available. For channel dimensions, see
page 32.
Options
Flex pendant channel
(3.28’ / 1m)
[FLK PEN]
Lenses (3.28’ / 1m)
[Clear: FLK MFC]
[Frosted: FLK MFL]
[Opal: FLK MOL]
Conductive
fastener
[FLK PEN CF]
Zinc
mounting
bracket
[FLK ZMB]
End cap
[FLK PEN EC]
End cap
with hole
[FLK PEN ECH]
Conductive
end cap
[FLK PEN CEC]
Steel rod with
threaded ends
[1.64’ / 0.5m: FLK PEN SR05]
[3.28’ / 1m: FLK PEN SR1]
Stainless steel wire
[3.28’ / 1m:
FLK PEN SSW1]