Acclaim Lighting Ai Flex Interior, User Manual

Page: 7 / 40

5
www.acclaimlighting.com
+24V
W1
W2
W3
W4
W4
W3
W2W1
+24V
TO SOLDER THE TAPE
Once cuts are made to a Ai Flex tape, connections need to be made to the new sections.
Either side of each cut line are bare copper contact pads where you can make connections
either by soldering feed wires.
Note: When soldering, minimize the time spent heating the tape
to avoid damage to the nearby components.
CONTACT PADS
Ai Flex tapes have five connections.
At each cut line the positive contact is
marked
+24V
.
+24V
W1
W2
W3
W4
W4
W3
W2W1
+24V
Tape cut line
TO CUT THE TAPE
Ai Flex tapes are marked with a cut
line every 6.5” (166mm) - every six LED
emitter clusters.
IMPORTANT: Do not cut the tape
at any location other than the cut
line as this will prevent correct
operation and also void your
warranty. Ensure the cut is made
cleanly along the line.
CUTTING AND CONNECTING THE TAPE
Ai Flex tapes are supplied with a fixed 3.28’ (1m) feed cable (with bare tails). Once cut to size,
new tape connections can be made by soldering suitable feed cables (see page 7).
+24VDC
Warmest emitters
Coolest emitters