18
www.acclaimlighting.com
+24
V
W1
W2
W3
W4
TO MOUNT THE CHANNEL
1 If necessary, carefully solder to the contact
2 Fit the Ai Flex tape to the channel (see
3 Attach two or more
Zinc mounting
brackets
to the mounting surface using
screws appropriate to the surface type.
4 Clip or slide the channel into the
mounting brackets.
If necessary, solder
the link cables to
the contact pads
Clip or slide the
channel into the
mounting brackets
TO FIT A LENS
1 Measure the exact length of lens required
between the end caps at each end of the channel.
2 Carefully cut the lens to length. Ensure that any
resulting burrs are removed.
3 Insert one end of the lens against one of the end
caps so that it locates into the ‘Lens recess’ within
the channel (see right).
4 Once the first part of the lens has correctly
located, run your thumb gently along the length
of the lens to push the remainder into place.
Lens
recess
Locate the first section of
lens into the channel and
then run your thumb along
it to push the remainder into
place.
+24
V
W1
W2
W3
W4
Note: Ensure sufficient
strain relief where the
cables enter the channel.
Summary of Contents for Ai Flex Interior
Page 1: ...User guide Ai Flex Interior...
Page 2: ......
Page 39: ......
Page 40: ...www acclaimlighting com...