Installation –
Preparing and fixing the wallbox in place |
17
Preparing and fixing the wallbox in place
Continue to prepare the wallbox:
8
Open the housing cover of the wallbox using the
triangular key and lower it.
T
T
T
9
Loosen the screw holding the internal electronic
components cover in place using the screwdriver
(Torx 20) and put it aside.
y
Keep the screw in a safe place.
M
ETER
M
E
T
E
R
C
N
T
R
L
CONTROL
CONTROL
M
ETER
10
Use the utility knife to cut an opening for the pow-
er supply cable into the large rubber grommet, and
then insert it into the housing base.
y
Insert the two smaller grommets into the hous-
ing base.
y
For wiring up group installations, you must also
make cuts into the two smaller grommets for the
data cables (see "Data cable connections" on
page 19).
M
ETER
M
E
T
E
R
C
N
T
R
L
CONTROL
CONTROL
M
ETER
11
Insert the power supply cable into the housing base
through the large rubber grommet.
y
For wiring up group installations, you must also
insert the data cables into the housing base
through the small grommets.
M
ETER
M
E
T
E
R
C
N
T
R
L
CONTROL
CONTROL
M
ETER
