Configuring the Wallbox eMH3 –
Set-up via Charge Point Administration application |
35
7
Use the selection list at the bottom to enter the de-
sired number and click the
Save
button.
y
These Extender charging stations are then
displayed together with the Controller in the
Products > Installation
tab.
y
The
Cancel
button returns you to the
Products
> Catalog
list without making a selection.
NOTE
Completing the system configuration
Repeat these steps to add all additional Extender charging stations in the system.
8
Navigate to the bottom of the
Products > Instal-
lation
tab and click the
Create new configura-
tion
button.
9
Switch to the
Overview > Details
tab: this shows
at a glance whether your system is set up correctly.
After you have set up all Extender charging stations for the Controller, you must also define the maximum available
current for the entire system.
To do so, proceed as follows:
10
Make sure you are still logged into the
Charge
Point Administration
application in the
Installer
role.
y
If not, change your role as described in step
4
.
11
Switch to the
Products > Installation
tab, and,
in the
Actions
column, click the button for the
Controller charging station marked with .
12
In the
Maximum Value
field in the
LIMIT (LIM
SL-1)
section, enter the desired maximum current
(for example:
32 A
) for the entire system.
y
Confirm with the button on the right.
13
Switch to the
Operation > Load Management
tab and enter the same value in the
Maximum
Current
field in the
Basic Settings
section that
you entered for the
Maximum current
in step
12
(for example:
32 A
).
y
Confirm with the
Save
button.
