xx2100000480
2 In the
Fronius Add-in
window, select the
Settings
to be used, such as
Metric
,
Imperial
,
EN standard
(European standards) or
AWS
standard.
3 In the
Fronius Add-in
window, click
Search weld modes
. The
Fronius Weld
Mode Search
window is displayed:
xx2100000479
4 In section
Weld Mode Search Criteria
, define the welding parameters (wire
size, gas, wire type) and process (CV, Pulse, PMC) upon which the search
should be based.
5 Select
Search
. The search results are displayed in the window. The synergic
lines can be cleared (
Clear All
) on the right-hand window or kept as they are.
6 Transfer desired Synergic lines from the left-hand window over to the
right-hand window as needed, and then click
OK
.
7 In the
Fronius Add-in
window, select
Update Controller
and then select
View Weld Modes
to make sure changes were applied.
84
Application manual - Fronius TPS 320i/400i/500i/600i with RI-FB inside/i interface
3HAC065012-001 Revision: C
© Copyright 2004-2021 ABB. All rights reserved.
7 Fronius EtherNet/IP configuration
7.3.3 Adding or removing synergic lines from RobotStudio
Continued
Summary of Contents for Fronius TPS 320i
