ABB Fronius TPS 320i, Applications Manual

Page: 51 / 88

4.4 Weld editor in Job mode with correction
Ignition parameters
Tap the Ignition tab to view or modify the ignition phase parameters.
Note
Do not manipulate seam/welddata using the RAPID data type editor. This can
result in unwanted behavior and wrong welding parameters which can in worst
case damage your welding equipment. Use the Weld mode editor instead.
Note
The ignition phase parameters can only be modified in manual mode.
Tip
To copy the current weld phase mode settings, toggle Use Weld Phase Mode
off, on, and then off again.
xx1900002414
Description Button
The blue refresh button is used to return to the Weld Phase tab. Refresh
The green check button is used to confirm any changes made. Confirm
The red cancel button is used to cancel any changes made and return
to the previous values. Cancel
Description Parameter
The delay (in seconds) from the time the arc is considered stable
at ignition until the heat phase is started. Ign Move Delay
Continues on next page
Application manual - Fronius TPS 320i/400i/500i/600i with RI-FB inside/i interface 51
3HAC065012-001 Revision: C
© Copyright 2004-2021 ABB. All rights reserved.
4 Weld editor interface
4.4 Weld editor in Job mode with correction