ABB Fronius TPS 320i, Applications Manual

Page: 64 / 88

5.2 Overview of the Fronius TPS/i Add-In
General
This section describes the available configuration options for the Fronius TPS/i
Add-In used in the setup. The add-in can be launched by clicking
Fronius TPS/i .
xx1900002428
Note
The Fronius TPS/i add-in is used to select the weld modes to be used in the robot
from among the many weld modes available in the welder. This simplifies
choosing weld modes for the user and allows engineering staff to select only the
weld modes they want the user to use.
The Fronius TPS/i add-in consists of a list of controllers and its tasks in drop-down
menus. The status of the controller is displayed in the status section. The list can
hold virtual controllers as well as real controllers.
xx1900002429
Welder section
In the Welder section you can specify the IP Address of the welder service port.
Note
The IP address can be stored in the system parameters for later use. If the add-in
started, the IP address is read from the parameter settings. See
System
parameters on page 20 .
Credentials are mandatory to be able to download the weld modes (Synergic lines)
and the Joblist.
Continues on next page
64 Application manual - Fronius TPS 320i/400i/500i/600i with RI-FB inside/i interface
3HAC065012-001 Revision: C
© Copyright 2004-2021 ABB. All rights reserved.
5 The Fronius TPS/i RobotStudio Add-In
5.2 Overview of the Fronius TPS/i Add-In