ABB Fronius TPS 320i, Applications Manual

Page: 53 / 88

xx1900002413
Description Button
The blue refresh button is used to return to the Weld Phase tab. Refresh
The green check button is used to confirm any changes made. Confirm
The red cancel button is used to cancel any changes made and return
to the previous values. Cancel
Description Parameter
The distance during which the heat data is active at the start of
the weld. Heat Dist / Heat as time
If the parameter Heat as time is active the distance will be re-
placed by time (in seconds).
The welding speed during the heat phase at the start of the
weld phase. Heat Speed
Not selected – Select weld parameters during ignition phase
manually. Use Weld Phase Mode
Selected – Use the parameters from the Weld tab. This is the
default mode.
The job (schedule) that should be selected within the welder. Job number
The information displayed in the Job number is:
Job number, Job name.
This is the wire feed speed (Power). In this mode, the wire feed
speed can be adjusted in the range of +/- 20 % in 1% incre-
ments. Wire Feed Speed
This parameter represents the arc length (Voltage). Arc Length Correction
In this mode, the Arc Length Correction can be adjusted in the
range of +/- 10 steps in 0.1 increments.
Continues on next page
Application manual - Fronius TPS 320i/400i/500i/600i with RI-FB inside/i interface 53
3HAC065012-001 Revision: C
© Copyright 2004-2021 ABB. All rights reserved.
4 Weld editor interface
4.4 Weld editor in Job mode with correction
Continued