ABB ACS880-04F, Hardware Manual, Page: 20 / 172

20 Introduction to the manual
Contents of the manual
This manual contains the instructions and information for the basic drive module
configuration. The chapters of the manual are briefly described below.
Safety instructions gives safety instructions for the installation, commissioning, operation
and maintenance of the drive module.
Introduction to the manual introduces the manual.
Operation principle and hardware description describes the drive module.
Guidelines for planning the mechanical installation guides in planning drive cabinets and
installing the drive module into a user-defined cabinet. The chapter gives cabinet layout
examples and free space requirements around the module for cooling.
Mechanical installation describes how to install the drive module mechanically.
Guidelines for planning the electrical installation instructs in the motor and cable selection,
protections and cable routing.
Electrical installation gives instructions on the wiring of the drive.
Installation checklist contains lists for checking the mechanical and electrical installation of
the drive.
Start-up refers to the start-up instructions of the cabinet-installed drive.
Fault tracing describes the LED indications and refers to the fault tracing instructions of the
drive.
Maintenance contains maintenance instructions.
Ordering information gives ordering information on additional components available from
ABB for the drive module installation.
Technical data contains the technical specifications of the drive module, eg, the ratings,
sizes and technical requirements, provisions for fulfilling the requirements for CE and other
markings.
Dimension drawings contains dimension drawings of the drive module installed into a
Rittal TS 8 cabinet.
Example circuit diagram shows an example circuit diagram for a cabinet-installed drive
module.
Safe torque off function describes the Safe torque off function of the drive and gives
instructions on its implementing.
Resistor braking describes selection, protection and wiring of optional brake choppers and
resistors. The chapter also contains technical data.
du/dt and sine filters describes how to select d u /d t and sine filters for the drive.
Categorization by frame size and option code
The instructions, technical data and dimension drawings which concern only certain drive
frame sizes are marked with the symbol of the frame size (R10 or R11). The frame size is
marked on the type designation label.
The instructions and technical data which concern only certain optional selections are
marked with option codes, eg, +J410. The options included in the drive can be identified
from the option codes visible on the type designation label. The option selections are listed
in section
Type designation key on page 35 .