ABB ACS800-04, Hardware Manual

Page: 21 / 118

About this manual
21
Product and service inquiries
Address any inquiries about the product to your local ABB representative, quoting
the type code and serial number of the unit in question. A listing of ABB sales,
support and service contacts can be found by navigating to
www.abb.com/drives and
selecting Drives – Sales, Support and Service network on the right pane.
Product training
For information on ABB product training, navigate to www.abb.com/drives and select
Drives – Training courses on the right pane.
Unpack and check the units.
Check that all necessary optional modules and
equipment are present and correct.
Only intact units may be started up. If the converter has been non-operational for
more than one year, the converter DC link
capacitors need to be reformed. Ask ABB for
instructions.
Check the installation site. Technical data
If the drive is about to be connected to an IT
(ungrounded) system, check that the drive is not
equipped with EMC E202. The ACS800-04/U4 and ACS800-04M : Type
code . For instructions on how to disconnect the
EMC filtering, contact ABB.
Route the cables. Planning the electrical installation : Routing the
cables
Check the insulation of the motor and the motor
cable. Electrical installation : Checking the insulation of
the assembly
Install the drive. Connect the power cables. Connect
the control and the auxiliary control cables. Electrical installation, Resistor braking
(optional)
Commission the drive. Appropriate firmware manual
Commission the optional brake chopper (if present). Resistor braking
Operating of the drive: start, stop, speed control etc. Appropriate firmware manual
Task See