ABB ACS180, Hardware Manual, Page: 7 / 168

50 Relay cable ..........................................................................................................
50 Control panel to drive cable ............................................................................
50 PC tool cable ......................................................................................................
50 Routing the cables ...................................................................................................
50 General guidelines – IEC ...................................................................................
51 General guidelines – North America ..............................................................
52
Continuous motor cable shield/conduit or enclosure for equipment on
the motor cable .................................................................................................
53 Separate control cable ducts ..........................................................................
53 Implementing short-circuit and thermal overload protection ........................
53 Protecting the drive and input power cable in short-circuits ..................
53 Protecting the motor and motor cable in short-circuits ..........................
54
Protecting the drive, and the input power and motor cables against
thermal overload ...............................................................................................
54 Protecting the motor against thermal overload ........................................
54
Protecting the motor against overload without thermal model or
temperature sensors ........................................................................................
55 Implementing motor temperature sensor connection .....................................
55 Protecting the drive against ground faults .........................................................
55 Residual current device compatibility ..........................................................
56 Implementing the Emergency stop function ......................................................
56 Implementing the Safe torque off function ........................................................
56 Using a safety switch between the drive and the motor .................................
56 Implementing the control of a contactor between drive and motor .............
57 Protecting the contacts of relay outputs ............................................................
6 Electrical installation
59 Contents of this chapter .........................................................................................
59 Warnings ....................................................................................................................
59 Required tools ...........................................................................................................
60 Measuring the insulation ........................................................................................
60 Measuring the insulation resistance of the drive .......................................
60 Measuring the insulation resistance of the input power cable ...............
60 Measuring the insulation resistance of the motor and motor cable ......
61 Earthing system compatibility check ...................................................................
61 EMC filter ............................................................................................................
61 When to disconnect the EMC filter ................................................................
62 Disconnecting the EMC filter ..........................................................................
63 Guidelines for installing the drive to a TT system ......................................
63 Identifying the grounding system of the electrical power network .......
65 Connecting the power cables ................................................................................
65 Connection diagram .........................................................................................
66 Connection procedure .....................................................................................
68 Connecting the control cables ...............................................................................
69 Default I/O connection diagram (ABB standard macro) ..........................
Table of contents 7