MYLOS
®
Building Automation |
Technical features 9
MYLOS
®
Building Automation
Technical features
- The ambient temperature controller must not be
exposed to direct contact with liquids.
- Temperature regulation will also be affected
by exposure to heat from electrical appliances
and direct sunlight on the ambient temperature
controller.
Requirements for commissioning
A PC with ETS (ETS 2 V1.3a or higher) and a connection to the ABB i-bus®, e.g. over a KNX interface, is required
to commission the device.
The device is ready for operation once it is connected to the bus voltage.
Auxiliary voltage is not required.
The device must be installed and commissioned by a qualified electrician only. The relevant standards, directives,
regulations and requirements for planning and installation of electrical systems must be observed.
- The device must be protected from moisture, dirt and damage during transport, storage and operation.
- The device must be operated in accordance with the specified technical data only.
Supplied state
The device is supplied with the physical address 1.0.1. Application program, group addresses and parameters must
be loaded during commissioning.
Assignment of the physical address
The physical address, group address and parameters are assigned in the ETS.
Cleaning
The device can be cleaned with a dry cloth if it is dirty. If this is not sufficient, use a cloth lightly moistened with a
detergent solution. Never use aggressive cleaners or solvents.
Maintenance
The device is maintenance-free. It must not be repaired by third parties if it is damaged, such as in transport and/or
storage. The guarantee is cancelled if the device is opened.
The device must be accessible at all times for operation, testing, inspection, maintenance and repair.