MYLOS
®
Building Automation |
Commissioning 59
MYLOS
®
Building Automation
Commissioning
31
Comfort setpoint - cooling
Adjustment
2 byte EIS1 DPT 9.001
C,R,W
Object is visible if the individual setpoint preset has been set in the parameters.
This data item forms the 2-byte KNX object and can be received. It is relevant for absolute
setpoint management. When a setpoint for an operating mode is received,
setpoint is automatically enabled.
32
Standby setpoint - cooling
Adjustment
2 byte EIS1 DPT 9.001
C,R,W
Object is visible if the individual setpoint preset has been set in the parameters.
This data item forms the 2-byte KNX object and can be received. It is relevant for absolute
setpoint management. When a setpoint for an operating mode is received,
setpoint is automatically enabled.
33
Night setpoint - cooling
Adjustment
2 byte EIS1 DPT 9.001
C,R,W
Object is visible if the individual setpoint preset has been set in the parameters.
This data item forms the 2-byte KNX object and can be received. It is relevant for absolute
setpoint management. When a setpoint for an operating mode is received,
setpoint is automatically enabled.
34
Heat setpoint - cooling
Adjustment
2 byte EIS1 DPT 9.001
C,R,W
Object is always visible if the individual setpoint preset has been set in the parameters.
This data item forms the 2-byte KNX object and can be received. It is relevant for absolute
and relative setpoint management. When a setpoint for an operating mode is received,
setpoint is automatically enabled.
Value 99.9 means heat protection = off.
35
Receiving current status
Adjustment
1 bit EIS1 DPT 1.001
C,R,W
This 1-bit communication object is enabled, if the proper parameter has been set to „yes“.
This object resets the comfort setpoint to the parametrised value.
This data item forms the 1-byte KNX object and can be received only. Manual operation
is reset when a „1“ is received.