Rebooting the AastraLink
7-6
41-001190-02 Rev. 01, Rel. 1.2
AastraLink Pro 160 Administrator Guide
Rebooting Using the Reset Switch (Hard Reboot)
You can reboot the AastraLink device using the reset switch as long as the LED
on the front of the Aastralink is in one of the following states:
•
Flashing green
•
Flashing red
•
Steady red
See the LED monitoring table on
page 7-3
for a description of each LED state.
Use the following procedure to reboot the AastraLink.
Manual Reboot Procedure
Step
Action
1
Locate the reset switch on the back of the device, as shown on the figure below.
2
Use the end of a paperclip to press, and then immediately release, the reset switch.
IMPORTANT: DO NOT KEEP THE SWITCH PRESSED IN.
After five seconds, the LED turns red momentarily. This indicates that the AastraLink is resetting
hardware. The AastraLink then begins its normal reboot process. The LED turns steady green as the
device performs internal hardware diagnostic tests. Once tests are complete, the LED flashes green,
indicating a successful reboot. The device is now up and running, ready to process calls.
Back Panel
12 VDC 1.25A
A
B
LAN
WAN
/ FAX
TM8DC
/ FAX
1
2
3
4
5
6
LINE
Reset Switch
Summary of Contents for AastraLink Pro 160
Page 1: ...Administrator Guide Release 1 2 AastraLink AastraLink 41 001190 02 Rev 01 160 160 Pro Pro ...
Page 358: ......
Page 359: ......
