A&D Omniace III RA2300A, Instruction Manual

Page: 162 / 196

19.
Troubleshooting
RA2300A Recorder (7001754-R01) 19-2
19.1.Troubleshooting and Inspection
If the recorder does not operate normally or need to be repaired after following the
instructions for abnormal conditions, please contact our sales offices listed at the end of
this manual.
Problem Possible cause Instruction Refer to
No power supply.
Nothing displayed
on the screen
The power switch is turned off. Turn on the power switch
Chapter
3
The power cord is not properly
connected.
After the power switch is turned off,
connect the power cord correctly, and then
turn on the switch again.
Chapter
3
The fuse is blown.
The AC line input fuse for this unit cannot
be replaced by the customer because this
fuse is placed inside the main unit.
Please contact us if the fuse may be
blown.
end of
this
manual
The screen is automatically
turned off.
Touching any button turns it on.
Chapter
16
The screen frozen Abnormal condition occurs in
the system.
Turn off the power switch, and then turn it
on again
Chapter
2
No reactions when
pushing any button
on the touch panel.
A recording operation is in
progress in Memory mode or
Multi-recorder mode. The start
LED or the copy LED is on.
Push the stop button on the operation
panel to stop measuring, and then push
any button.
Chapter
2
No recording
There is no recording paper. Insert recording paper.
Chapter
3
The printer block is opened. Close the cover of the printer block.
Chapter
3
The temperature of the
thermal head is abnormally
high. (The environment
temperature is over 40
degrees centigrade.)
Use the main body in a 0 to 40 degrees
environment.
Chapter
20
Not start recording
when pushing the
start button.
The start trigger is on. Turn off the start trigger.
Chapter
10
Recording is set as an
external synchronization
recording
Recording is started only after inputting a
pulse signal to a remote terminal.
Therefore, input the signal, and then push
the start button.
Chapter
17
There is no chart paper. Load a chart paper.
Chapter
3
Cannot save data to
the selected media.
The media is not formatted. Format the media.
Chapter
16
The disk space is insufficient. Erase unwanted files or use new media.
Chapter
16
The media is write-protected. Unprotect the media.
－
Not detected the
media.
The media is not correctly
formatted.
Format the media correctly.
Chapter
16
The media is damaged. -
－
Cannot specify and
control operation
through a
communication
interface.
The communication
parameters are not specified
correctly.
Specify addresses and communication
parameters correctly.
Chapter
16
NOTE