A&D Omniace III RA2300A, Instruction Manual

Page: 115 / 196

14. Replay Display (Displaying Recording Data)
RA2300A Recorder (7001754-R01) 14-7
14.6. Jump
Jump of Y-T waveform display position can be made after the time axis position is specified. Pressing
the Jump button on the upper part of the Replay screen displays the following screen.
14.6.1Basic Jump
14.6.2Time Jump
14.6.1. Basic Jump
Basic jump operation is made.
Start point: Jump to recording data start point
End point: Jump to the end point of the recording data
Trigger detection point: Jump to the trigger detection point for recording data
If there is no trigger detection point, jump is made to the start point.
Cursor X1/X2: Jump to current cursor position
14.6.2. Time Jump
Jump is made after the waveform display position is specified. Specify the time using the Time tab
on the Jump screen. Pressing the Apply and OK buttons execute a jump.
When the Apply button is pressed, the jump screen does not close the Jump screen even
after the jump execution. To execute jump continuously, this button is usable.
If the recording rate of the recording data is external sync, time jump cannot be made
because the time axis cannot represent as time. Use [14.6.3Address Jump]
14.6.3. Address Jump
Jump can be made after waveform position is designated in address. Open the Address tab on the
Jump screen, and then specify the address. Press the Apply button and OK button to execute a
jump.
TIPS
NOTE