A&D Omniace III RA2300A, Instruction Manual

Page: 117 / 196

14. Replay Display (Displaying Recording Data)
RA2300A Recorder (7001754-R01) 14-9
14.6.5. Event Jump
Marking information that is recorded in the recorded data is searched and jump is made.
(1) The Event tab on the Jump screen is displayed.
(2) Marking jump is executed when a search direction button is
pressed.
The event jump needs the data which it included E2 in.
To include E2 in the recording data, the following setting is necessary.
・
System- Recording Setup- Recording Channels: E2 ON
・
Amp Basics Screen : E2 ON
Marking jump is a jump to the mark address that is closest to the direction that is
specified by jump target address (Waveform, x1, x2). Also, a trigger mark is regarded as
a mark. If the mark is not found, jump to the start/end point is made.
(3) Jump to link data is made.
When this button is pressed after the making jump is made while the data file (extension of
IDX) recorded in the Multi Recorder mode is displayed. a jump to the link data (memory
recording data) is made.
14.7. Time Axis Magnification
To enlarge or compress the time axis, press
[Time Axis] button. The following screen
appears.
Press the Close button. After the screen is closed, the selected time axis scaling factor will be effective.
Scaling factor can be changed without seeing the screen through the following steps.
1) Press the left side of the time axis scaling button, and then make jog dial change
effective.
Scaling factor will be highlighted.
2) Change the value by turning the jog dial.
Time axis for waveform display will be enlarged or compressed according to the
scaling factor.
NOTE
(3)
(1)
(2)
(2)
TIPS
NOTE