A&D Omniace III RA2300A, Instruction Manual

Page: 106 / 196

13. Trigger Settings (Capturing Target Data to be Recorded)
RA2300A Recorder (7001754-R01) 13-10
NOTE
13.6. Trigger Settings for Event Amp
Trigger settings for event amp differs from those of other amps. The settings are made in the following
screen.
●
Trigger condition settings
Trigger condition Volt (Voltage input)
H The H condition is satisfied when the input voltage r2.5V or higher.
L The L condition is satisfied when the input voltage b0.5 V or lower.
NO Exempting from trigger conditions
In the event amp, a trigger is activated when first trigger condition is satisfied. If the trigger
condition has been satisfied, a trigger will be not be activated. Especially, for example,
one channel has already been satisfying the trigger condition in the OR mode, the trigger
will be activated even when other channel’s trigger condition is satisfied.
Trigger conditions for channels 1 to 8 are
set.
H, L, NO can be set.
If NO is set the check box is not displayed.
Trigger settings are made when the check
box is ticked.
AND: When all trigger conditions that
have been set are satisfied, a
trigger is activated.
OR: Either of the trigger conditions is
satisfied, a trigger is activated.