A-TS
48
https://a-ts.cn/en/
21: Disable PLC
If the setting is 21, the terminal is used to realize the flexible switching
between PLC operation and low level operating mode.
When the inverter is switched to low level operating mode, its start/stop,
operating direction, ACC/Dec time are shifted to the corresponding
operating modes accordingly.
22~24: Reference frequency setting method
Through the combination of the ON/OFF state of X1, X2 and X3, you can
select different frequency setting method, which will come into effect
regardless of P0.02.
Table 7-4 Frequency Setting Mode Selection
X3
X2
X1
Mode
OFF
OFF
OFF
None
OFF
OFF
ON
Digital setting 1
OFF
ON
OFF
Digital setting 2
OFF
ON
ON
Digital setting 3
ON
OFF.
OFF
VCI analog setting
ON
OFF
ON
CCI analog setting
ON
ON
OFF
Reserved
ON
ON
ON
LED keypad
25: Reserved
26: MS terminals
27: Terminal control mode is enabled
When this terminal function is enabled, the operating command is input
through this terminal forcibly. The inverter will be controlled in the
previous mode if FWD/REV terminal function is disabled.
28
～
29: Control mode selection X1~X2
Table 7-5 Control Mode Selection
X2
X1
Control mode
OFF
OFF
None
OFF
ON
LED keypad
