A-TS
67
https://a-ts.cn/en/
The PLC stage and PLC cycle are indicated by the 500mS signals from
output terminals Y1 and Y2 of open collector output or relay output. See
P6.00~P6.02.
Figure 7-24 Stop after a Single PLC Cycle
One’s place of PD.00, PLC running mode selection
0: Disabled
The PLC function is disabled.
1: stop after a single cycle
The inverter stops after a single cycle automatically. It will start given
another Run command.
2: Maintain value of the last stage after 1 cycle
The inverter holds the frequency and direction of the last stage after
single cycle.
3: ( Continuous cycle ) : The inverter continues running cycle after cycle
until Stop command is received.
Ten’s place of PD.00: Restart mode after PLC interruption:
0: start from the first stage
The inverter restarts from the first stage of PLC after interrupts, such as
Stop command, fault or poweroff.
1: continue from the stage frequency where the inverter stops. When the
inverter stops caused by Stop command or fault, it can record the time
PD.00 Simple PLC mode
Range: 0000
～
1123
【
0000
】
