3D Systems, Inc.
Installing New Material Cartridge
NOTE: Cartridges cannot be installed into a cold printer . The
printer must be warm before drawer will open and cartridges can
be installed .
To place a material cartridge into the MDM, perform the following steps:
1 . Obtain a new material cartridge ensuring that it is the same material as
currently installed in the MDM .
2 . If drawer is not already open, push to unlock drawer .
3 . Pull open the MDM drawer .
NOTE: The steps to install a support cartridge are the same as
installing a material cartridge .
NOTE: To install cartridges into the MDM drawer properly ensure
that the small cap be installed away from the user .
4 . Place cartridge in slot and push down until you hear it click in place .
5 . Vent each cartridge by loosening the material cap (A) by a 1/2 turn
counterclockwise .
6 . Close the MDM drawer (B), until it’s latched securely .
7 . Check the material level under the
Materials
tab on the UI to ensure
cartridge is ceded properly into MDM and ready to print .
A
B
34
Summary of Contents for ProJet 2500
Page 1: ...User Guide Original Instructions ProJet 2500 3D Printer System ...
Page 5: ......
Page 50: ...45 ...
