3D Systems, Inc.
MATERIAL CARTRIDGE REMOVAL AND INSTALLATION
When a material cartridge is empty and needs to be replaced, or if a partially filled container needs to be replaced with a full container,
perform the following procedure .
NOTE: It is important to verify the type of material currently in the MDM before proceeding with these steps .
IRRITANT! Wear protective clothing, disposable nitrile gloves, and goggles, while performing the following steps:
Removing Material Cartridge
NOTE: Cartridges cannot be removed from a cold printer . The
printer must be warm before drawer will open and cartridges
can be removed .
1 . The MDM drawer (A) is a push/push mechanism . Push to open
drawer, push to lock drawer .
2 . Open the MDM drawer by pushing the drawer panel in so it opens .
3 . Pull the MDM drawer open .
4 . Turn the material cap (B) a 1/2 turn to clockwise to tighten the vent cap .
5 . Press the release button (C) on the front . You will hear the cartridge
release . Pull the cartridge out of the slot .
6 . Dispose of the empty cartridge according to local regulations .
7 . Wearing nitrile gloves, use a disposable paper towel and wipe all material from the container seal assembly, if necessary you can
use some isopropyl alcohol on the paper towel to wipe up the excess material .
A
B
C
33
Summary of Contents for ProJet 2500
Page 1: ...User Guide Original Instructions ProJet 2500 3D Printer System ...
Page 5: ......
Page 50: ...45 ...
