3D Systems ProJet 2500, User Manual

Page: 22 / 53

3D Systems, Inc.
Material Delivery Module (MDM)
Support Material Containers A and B: These containers hold
the VisiJet® M2 SUP support material that is used for the build .
The support material is housed on the left side of the MDM .
These containers also incorporate smart cartridge technology that
contain the same type of information about the material that is
contained in the cartridge and the MDM .
Part Material Containers C and D: These containers hold the
cartridges of the VisiJet® part material, which are used to build
parts on the 3D printer system . The part material is housed
on the right side of the MDM. The refill containers incorporate
smart cartridge technology that contain information about the
material that is in the cartridge and the MDM . This information
enables the ProJet 2500 to verify that the user does not use the
wrong material, use material incorrectly, or use empty or expired
containers, ensuring the material is safe to use .
Electrical
Power Supply: In the rear of the printer there is an outlet to plug
in the power supply cord and a switch to turn the system on . This
is the only way to power the printer on from a complete shutdown
state . Do not use this switch to shutdown print . Printer should be
shutdown through the UI and brought back up by toggling the
power switch on the back . (A)
CAUTION: It is advised to never pull the plug or use
the switch as a means to power down the printer,
always power off through the Shutdown process on
the UI .
NOTE: Unless the printer will not be used for a
substantial period of time, it is best to leave it
powered on and in an Idle state .
A
D C
B
A
17