3Com Switch 7754, Configuration Manual

Page: 569 / 940

Displaying HA 569
Enabling Automatic
Synchronization
The Switch 7758 supports automatic synchronization. The master module stores
its configuration file and backups the configuration file to the slave module
simultaneously when the master’s configuration file is modified, so as to ensure
the consistency of the configurations of the master system and slave system.
You can enable/disable automatic synchronize of the Switch 7758.
Perform the following configuration in system view.
Synchronizing the
Configuration File of the
System Manually
The system can synchronize the configuration files on the master and slave
modules automatically. If you want to synchronize them yourself, you can do it
manually by using the command below.
Perform the following configuration in user view.
This operation can backup the configuration file to the slave module only if the
slave system operates normally. The configuration file will be fully copied at each
time the operation is executed.
Displaying HA
After the above configuration, you can execute the display command in any view
to view the HA configuration, and to verify the effect of the configuration.
Table 440 Perform the master-slave switchover manually
Operation Command Description
Perform the master-slave
switchover manually slave switchover Optional
Table 441 Enable automatic synchronization
Operation Command Description
Enter system view system-view -
Enable automatic
synchronization slave auto-update config Optional
Table 442 Synchronize the configuration file manually
Operation Command Description
Synchronize the configuration file
manually slave update configuration Optional
Table 443 Display HA
Operation Command Description
Display the switchover status
of the master/slave board display switchover state
[ slot-id ]
The display command can be
executed in any view.