3Com 8760 - Wireless Dual Radio 11a/b/g PoE Access Point, User Manual

Page: 110 / 261

5-8
C
HAPTER
5: C
OMMAND
L
INE
I
NTERFACE
The access mode shown in the following tables is indicated by these
abbreviations:
Exec (Executive Mode), GC (Global Configuration), IC-E
(Interface-Ethernet Configuration), IC-W (Interface-Wireless Configuration), and
IC-W-VAP (Interface-Wireless VAP Configuration).
General Commands
Table 11 General Commands
configure
This command activates Global Configuration mode. You must enter this mode to
modify most of the settings on the access point. You must also enter Global
Configuration mode prior to enabling the context modes for Interface
Configuration. See “Using the Command Line Interface” on page 5-1.
WDS Bridge Configures WDS forwarding table settings 5-84
Spanning Tree Configures spanning tree parameters 5-91
Ethernet Interface Configures connection parameters for the Ethernet interface 5-97
Wireless Interface Configures radio interface settings 5-103
Wireless Security Configures radio interface security and encryption settings 5-125
Rogue AP Detection Configures settings for the detection of rogue access points in the
network 5-125
Link Integrity Configures a link check to a host device on the wired network 5-141
IAPP Enables roaming between multi-vendor access points 5-144
VLANs Configures VLAN membership 5-145
WMM Configures WMM quality of service parameters 5-148
Command Function Mode Page
configure Activates global configuration mode Exec 5-8
end Returns to previous configuration mode GC, IC 5-9
exit Returns to the previous configuration mode, or exits the CLI any 5-10
ping Sends ICMP echo request packets to another node on the
network Exec 5-10
reset Restarts the system Exec 5-11
show history Shows the command history buffer Exec 5-12
show line Shows the configuration settings for the console port Exec 5-12
Command Group Description Page