3Com 8760 - Wireless Dual Radio 11a/b/g PoE Access Point, User Manual

Page: 202 / 261

5-100
C
HAPTER
5: C
OMMAND
L
INE
I
NTERFACE
ip dhcp
This command enables the access point to obtain an IP address from a DHCP
server. Use the
no form to restore the default IP address.
Syntax
[ no ] ip dhcp
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet)
Command Usage
• You must assign an IP address to this device to gain management access
over the network or to connect the access point to existing IP subnets. You
can manually configure a specific IP address using the
ip address
command, or direct the device to obtain an address from a DHCP server
using this command.
• When you use this command, the access point will begin broadcasting
DHCP client requests. The current IP address (i.e., default or manually
configured address) will continue to be effective until a DHCP reply is
received. Requests will be broadcast periodically by this device in an effort
to learn its IP address. (DHCP values can include the IP address, subnet
mask, and default gateway.)
Example
Related Commands
ip address (5-99)
Enterprise AP(config)#interface ethernet
Enter Ethernet configuration commands, one per line.
Enterprise AP(if-ethernet)#ip dhcp
Enterprise AP(if-ethernet)#