Prestige 650HW ADSL Router
4-8
Remote
Node
Configuration
Table 4-2 Remote Node Network Layer Options
FIELD DESCRIPTITON
EXAMPLE
My WAN Addr
Some implementations, especially UNIX derivatives, require separate
IP network numbers for the WAN and LAN links and each end to have a
unique address within the WAN network number. In that case, type the
IP address assigned to the WAN port of your Prestige.
NOTE: Refers to local Prestige address, not the remote router address.
NAT
Press [SPACE BAR] and then [ENTER] to select
Full Feature
if you
have multiple public WAN IP addresses for your Prestige.
Full
Feature
Select
SUA Only
if you have just one public WAN IP address for your
Prestige. The SMT uses Address Mapping Set 255 (menu 15.1 - see
section
7.3.1
).
Select
None
to disable NAT.
Address
Mapping Set
When
Full Feature
is selected in the
NAT
field, configure address
mapping sets in menu 15.1. Select one of the NAT server sets (2-10) in
menu 15.2 (see
the
NAT
chapter
for details) and type that number here.
When
SUA Only
is selected in the NAT field, the SMT uses NAT server
set 1 in menu 15.2 (see
the
NAT
chapter
for details).
2
Metric
The metric represents the “cost” of transmission for routing purposes.
IP routing uses hop count as the cost measurement, with a minimum of
1 for directly connected networks. Type a number that approximates the
cost for this link. The number need not be precise, but it must be
between 1 and 15. In practice, 2 or 3 is usually a good number.
2
Private
This determines if the Prestige will include the route to this remote node
in its RIP broadcasts. If set to
Yes
, this route is kept private and not
included in RIP broadcast. If
No
, the route to this remote node will be
propagated to other hosts through RIP broadcasts.
No
RIP Direction
Press [SPACE BAR] and then [ENTER] to select the RIP Direction.
Options are
Both
,
In
Only
,
Out
Only
or
None
.
None
Version Press [SPACE BAR] and then [ENTER] to select the RIP version.
Options are
RIP-1
,
RIP-2B
or
RIP-2M
.
RIP-1
Multicast
IGMP-v1
sets IGMP to version 1,
IGMP-v2
sets IGMP to version 2 and
None
disables IGMP.
None
IP Policies
You can apply up to four IP Policy sets (from 12) by typing in their
numbers separated by commas. Configure the filter sets in menu 25
first (see the
IP Policy Routing
chapter) and then apply them here.
3, 4, 5, 6