Prestige 650HW ADSL Router
Internet Access
3-21
Table 3-7 Internet Access Setup Menu Fields
FIELD DESCRIPTION
EXAMPLE
ISP’s Name
Enter the name of your Internet Service Provider. This
information is for identification purposes only.
MyISP
Encapsulation
Press [
SPACE BAR
]
to select the method of encapsulation
used by your ISP. Choices are
PPPoE
,
PPP
,
RFC 1483
or
ENET ENCAP
.
RFC 1483
Multiplexing
Press [
SPACE BAR
] to select the method of multiplexing
used by your ISP. Choices are
VC-based
or
LLC-based
.
VC-based
VPI #
Enter the Virtual Path Identifier (VPI) that the telephone
company gives you.
8
VCI #
Enter the Virtual Channel Identifier (VCI) that the telephone
company gives you.
35
ATM QoS Type
Press [SPACE BAR] and select
CBR
(Continuous Bit Rate) to
specify fixed (always-on) bandwidth. Select
UBR
(Unspecified
Bit Rate) for applications that are non-time sensitive, such as
e-mail.
UBR
Peak Cell Rate (PCR) This is the maximum rate at which the sender can send cells.
Type the PCR.
0
Sustain Cell Rate
(SCR)= 0
Sustained Cell Rate is the mean cell rate of a bursty, on-off
traffic source that can be sent at the peak rate, and a
parameter for burst-type traffic. Type the SCR; it must be less
than the PCR.
0
Maximum Burst Size
(MBS)= 0
Refers to the maximum number of cells that can be sent at the
peak rate. Type the MBS. The MBS must be less than 65535.
0
My Login
Configure the
My Login
and
My Password
fields for PPP and
PPPoE encapsulation only. Enter the login name that your ISP
gives you. If you are using PPPoE
encapsulation
,
then this
field must be of the form
user@domain
where domain
identifies your PPPoE service name.
N/A
My Password
Enter the password associated with the login name above.
N/A
ENET ENCAP
Gateway
Enter the gateway IP address supplied by your ISP when you
are using
ENET ENCAP
encapsulation.
N/A
Idle Timeout
This value specifies the number of idle seconds that elapse
before the Prestige automatically disconnects the PPPoE
session.
100
(Default)