Zünd L-1200, Руководство по эксплуатации

Страница: 98 / 142

Malfunctions PN series frame version
Error messages
5-2
110008,001,11-2009, jmu
5
5.2 Error messages
If the operating panel shows an error message:
•
Remove the cause of error
• Confirm the error message with the ENT key
The cutter system will then proceed in the ON-LINE mode or give you more informa
-
tion on the display about how to rectify the error.
An error message:
– Can contain several display pages
– Can be displayed in its entirety by pressing the ENT key several times
The following table contains the most important error messages and is arranged ac
-
cording to error numbers.
0101 Serial interface Parity
Causes Parity settings on PC and plotter are different, noise on the data cable.
Action Check RS232-settings on PC and plotter, check if there are noise sources
near the data cable, connect PC and plotter to the same mains outlet.
Hint Test the data transfer using test function 8 (RS232 test) and observe the
data that is received using test function 1 (terminal).
0102 Serial interface Frame
Causes Different data formats (data, startbit, stopbit) on the PC and plotter, different
baud rates, undefined data, PC switched off.
Action Check RS232-settings on PC and plotter.
Comment This message is disabled when SCI-diagnostic is set to level 1 or 2. Enter
ESC 515, then use the > key to select 1 or 2 and complete using ENT. If
"Frame" determines another error in the serial interface at the same time,
"Frame" is displayed at level 1.
0103 Serial interface Buffer overflow
Causes Plotter input buffer overflows, transmission stop was ignored. The data
cable may not be suitable or is defective (if using hardware protocol) or the
PC and plotter protocol settings are different.
Action Check protocol settings on PC and plotter, check data cable, use test func
-
tion 8 (RS232-test).
0104 Serial interface Noise detected
Causes Noise on the serial link
Action Check if there are noise sources near the data cable, connect PC and plot
-
ter to the same mains outlet.
Comment This message is disabled when SCI-diagnostic is set to level 1 or 2. Enter
ESC 515, then use the > key to select 1 or 2 and complete using ENT. If
"Noise detect" determines another error in the serial interface at the same
time, "Noise detect" is displayed at level 1.
Hint Use Test function 8 (RS232-Test)
0106 Replot not available Still receiving data
Causes Replot function selected while the plotter is still receiving data on the serial
input.
Action Clear error message, only select replot after the first job has finished.