Zünd L-1200, Руководство по эксплуатации

Страница: 76 / 142

Controls and operation PN series frame version
Command description
4-28
110006,001,11-2009, jmu
4
E.g.: POT - module 1, DRT - module 2
LASER (223) The commands in this submenu are valid only in conjunction with a laser system. For
a description of the commands, refer to the documentation for the laser system in
section 3.
PASSEPARTOUT (224) This submenu contains commands for the PPT tool.
DELAY (2241) Set the delay for the PPT tool (in milliseconds).
The default value is 300ms.
Desired delay:
– Enter using the numeric keypad.
– Confirm with the ENT key.
– Save as a configuration parameter, if required.
LINK TO TOOL (2242) You can define the tool module into which the PPT tool is inserted here.
Possible inputs: 0, 1, 2, 3, 4
Tool number:
– Enter using the arrow keys (left/right) or the numeric keypad.
– Confirm with the ENT key.
– Save as a user parameter, if required.
CUTTING TOOL (225) The submenu for the cutting of foils.
WIDTH (2251) This command is valid only for cutting and drawing head type C2-P. Use this com
-
mand to specify the width for automatic foil cutting.
Input range: 0mm to max. width of working surface
Desired width in millimetres:
– Enter using the numeric keypad.
– Confirm with the ENT key.
– Save as a configuration parameter, if required.
PRESSURE SWITCHING
(226)
This submenu contains commands for the creasing tool.
LINK TO TOOL (2261) For the creasing of cardboard, it is possible to switch the contact pressure automati
-
cally and dependent on direction.
– The creasing tool
– Switching the contact pressure
This command defines the tool module for
LINK TO TOOL (2222)
POT & DRT/EOT (2224) = ON LINK TO TOOL (2312)
POT & DRT/EOT (2224) = OFF