Zünd L-1200, Руководство по эксплуатации

Страница: 100 / 142

Malfunctions PN series frame version
Error messages
5-4
110008,001,11-2009, jmu
5
0317 AC zero mark X Permanent light
Causes X-axis zero mark sensor is defective (permanent light), defect on C-board or
interruption between C-board and master board.
Action Troubleshooting: see chapter "Zeromarks" for more information.
0318 AC zero mark Y Permanent light
Causes Y-axis zero mark sensor is defective (permanent light), defect on X-board or
interruption between X-board and master board.
Action Troubleshooting: see chapter "Zeromarks" for more information.
0327 AC Init-Fault Z-Pen Try to remove tool
Causes Z-axis (R-axis) blocked by the tool holder
Action Switch off plotter and remove tool holder. Reinsert tool holder after the initi
-
alization process
0357 2T tool change Diff. too low
Causes Less than two revolutions for a tool change from one tool to the other.
Action Check the mechanics and set the number of revolutions for a tool change to
two or more revolutions.
0358 2T tool change Diff. too high
Cause More than 16 revolutions for a tool change from one tool to the other.
Action Check the mechanics and set the number of revolutions for a tool change to
16 or fewer revolutions.
0401 HPGL-Parser Unknown syntax
Cause Invalid HPGL-character in the plotfile, noise on the data line
Index ASCII-Code of the cause
Text Current HPGL-command
Action Check plotfile and interface. It may be the case that sections of the plotfile
were not transferred.
Remarks The current command is terminated. This message is disabled when SCI-
diagnostic is set to level 2. Enter ESC 515, then use the > key to select 2
and complete using ENT.
0402 HPGL-Parser Number of parameters
Cause Invalid number of parameters, caused e.g. by a letter in a number, noise
Index Required number of parameters
Text Current HPGL-command
Action Check plotfile and interface. It may be the case that sections of the plotfile
were not transferred.
0801 Emergency stop <ENT> to reinit
Cause Emergency stop initiated
Index 0 : In normal cycle 1: In the test cycle
Action If initiated in a normal cycle, remove the reason for the emergency stop and
switch plotter off and on. If the reason is not clear, possible causes could be
a interrupted emergency loop, a defective master board, a short circuit to a
voltage > 2.5 volts or noise.If initiated in a test cycle a hardware error or
noise caused the message. Possible causes could be a short circuit against
ground or case, or a defective master board.