Zünd L-1200, Руководство по эксплуатации

Страница: 71 / 142

PN series frame version Controls and operation
Command description
4-23
110006,001,11-2009, jmu
4
MODE (128) This command:
– Is valid only for plotter types "Marker" and "Marker/Cutter" used in the textile in
-
dustry
– Defines the feed cycle for the material feeding system
Possible settings: VACUUM, VAC + STOP, NO VAC
With VACUUM, the material is held down by vacuum. The plotter is equipped with a
vacuum valve that reverses the air flow during feeding.
With VAC.+ST (Vacuum and Stop), the material feeding procedure is as follows:
•
The beam moves to the rear.
• The feeder elements hold down the material.
• The vacuum valve reverses the air flow; an air cushion is generated between ma
-
terial and vacuum plate.
• The plotter goes into standby. The display shows:
• Now the cut material can be removed from the vacuum plate.
• The material feed is carried out when the ENT key is pressed.
With NO VAC, the material is fixed by the clamping beam and take-up device -
without vacuum. The vacuum is not activated during feeding.
Attention !
If the mode is NO VAC and the vacuum pump/blower is switched on at the keypad,
the vacuum is not released during feeding - error "X-Override" appears.
CONFIGURATION (129) The following commands:
– Define the control of the material feeding system
– Are factory-adapted to the installed material feeding system and stored as confi
-
guration parameters
ROLL OFF (1291) This command defines the take-up device.
Possible settings: MANU / DRIVEN / CORE / EXTERNAL
Feed
Continue with ENT.
Setting Take-up device
MANU Not installed or manual device
DRIVEN Motor-driven
CORE Paper take-up with core, motor-driven for tex
-
tile plotter Marker/Cutter
EXTERNAL External device