Zünd L-1200, Руководство по эксплуатации

Страница: 103 / 142

PN series frame version Malfunctions
Error messages
5-7
110008,001,11-2009, jmu
5
1602 Airpressure Check Airpressure failed
Cause Compressed air monitoring was activated. Low air pressure detected for the
vacuum zones (LC-16/... type cutters) or for the foil cover brakes (LC-27/
32T).
Action Check whether compressed air is available and whether the pressure that
has been set is correct. If this is correct, check the pressure switch and
wiring (connection to the pressure sensor on S13 of the 3 axes board).
Comment The error can be cleared. If the pressure or a pressure-switch fails perma
-
nently, the error message is suppressed after two subsequent clears.
1610 Error DRT Overtemp
Cause The DRT (Driven Rotary Tool) sensed excess temperature.
Action Check initialisation, offset and down position according to the DRT manual.
To avoid overload, do not make the cut any deeper than necessary. Check
the free movement of the axis to which the knife is attached (caution! The
tool must be unplugged first!) If the error is also reported when the tool is not
connected, check the wiring and Y board. Replace the DRT if the message
is issued when the tool is not hot. If the cut material is too heavy, wait and
allow the tool to cool down.
Comment See the next message (1611) for further information.
1611 Error DRT Overcurrent
Cause The DRT (Driven Rotary Tool) current exceeded the preset limit for a while.
Once the current reaches the limit, the tool is lifted, if it falls under the limit
the tool is lowered again. This message is issued if the tool is lifted more
than 1mm without any reduction of the current.
Action Check initialisation, offset and down position according to the DRT manual.
Check if there is some material between knife and tool or if the friction is too
high. (Caution! The tool must be unplugged first!) Replace the DRT if neces
-
sary.
Comment Heavy material can cause this message. See also message (1610).
1620 Warning Sheet Feeder Material not in pos.
Cause If a sheet feeder unit is connected to the plotter, the 'material in position'
signal of that unit is checked before the cutter starts feeding. If this signal is
not received within 20s this message comes up.
Action If there is no material or it is not in the right position, fix that problem first,
then clear the message. Check the hardware if the message continues to be
displayed even when the sheet feeder is switched to manual.
Comment Ask for more information about the sheet feeder unit.
1621 Sheet Feeder No response
Cause The SPI-slave 'Sheet Feeder' is activated but was not detected when the
plotter was powered up.
Action Check the sheet feeder connection and the hardware. If necessary, deac
-
tivate the SPI-slave after clearing the message. (<ESC> 55155 in the ser
-
vice mode)
Comment More information is provided in the the sheet feeder unit documentation.