Zünd L-1200, Руководство по эксплуатации

Страница: 102 / 142

Malfunctions PN series frame version
Error messages
5-6
110008,001,11-2009, jmu
5
1002 Check axis tool T or Z is faulty
Cause The head recognised requires an axis (T- or R-axis) for which an error was
determined after power up (check axes).=> Axis problem or wrong head
recognition.
Action Analyse the problem if the incorrect head is displayed when the plotter is
switched on. See chapter "Head recognition code" in the description of the
electronics. If head recognition functions correctly, use test function 100
(diagnostic display) to analyse the problem for the axes and check the rele
-
vant cables and components. See chapter "Check axes" in the description
of the electronics.
1004 Head not permitted Turn off plotter!
Cause The head recognised is not allowed on a S-type plotter (heavy heads).
Text Recognised head
Action Remove the head, check the connector for the head flat cable on the Y
board. If the text displays an incorrect head type, use the "Head recognition
code" chapter in the description of the electronics to analyse the problem.
1005 Function not allowed Job is still active
Cause The "Select tool" option in the menu was used even though the job has not
yet ended.
Action Allow the job to finish or delete the buffer.
1007 Tool-DST Counter Change the tool
Cause Work distance counter reached the maximum value.
Action Exchange the tool and set a new maximum (ESC 2293). See the user
manual for more information about this function.
1201 Keyboard Fault A key is pressed
Cause Pressed key detected when plotter is switched on.
Action Press the associated key (to release it), use test function 7 (keyboard
check) where necessary
1301 Vacuum width Not initialised
Cause Uninitialised vacuum width
Action Initialise the vacuum and save the settings (see description)
1401 Error Uniboard Axis override
Cause The axis that is controlled by the UNI-Board is blocked or has been pushed
out of its setting position.
Action Switch off plotter and check the axis.
1406 Error Uniboard Axis blocked?
Cause Axis on the UNI board did not move far enough during the axis test
Action If "Mincurrent" (Error 1405) is also reported, solve the "Mincurrent" problem
first. If the axis was in motion prior to the axis check, switch the plotter off
and on again.
1601 Vacuum pump Error
Cause The temperature sensor on the vacuum pump switched the pump off.
Action Clear error and wait until the pump starts again. If necessary, determine the
reason for the cut-out.