Zünd L-1200, Руководство по эксплуатации

Страница: 67 / 142

PN series frame version Controls and operation
Command description
4-19
110006,001,11-2009, jmu
4
Tz-MODULE (118) All functions and settings within this submenu are relevant only for tool head type Tz.
The following commands are described in section 3 in the specifications for the Tz
head.
POS UP (1181)
POS DOWN (1182)
Z-OFFSET (1183)
Z-INIT (1184)
Z-INIT AUTO (1185)
Z-LOWER (1186)
Z-LIFT (1187)
MODE (1188)
PRESSURE (1189)
FEED (12) The following commands are used to control the material feeding system.
LENGTH (121) To define the feed length.
The feed length in millimetres:
– Enter using the numeric keypad.
– Confirm with the ENT key.
VAC TIME (122) Determines the period between the lowering of the feeder elements and the start of
feeding.
This time is required to create the vacuum or a cushion of air.
Important !
If you are operating the XL-1200LC cutter in combination with a blower, set this value
to 0.
FEEDER (123) A foil sensor is assigned to each feeder element on the table. If the plotter is confi
-
gured for foil feeding, the feeder elements are monitored and controlled by the foil
sensors.
When variable feeder elements are used, all elements are switched to and controlled
by the command "FEEDER 1 (1231)".
All feeder elements outside of the foil should be fixed using the fixing button; see the
section "Feed systems".
These commands can be used to do the following for each of the four feeder ele
-
ments:
– Switch on (ON)
– Switch off (OFF)
– Set to automatic (AUTO)