4、REAR WHELL COMPONENT
27
CHK
ADJ
NO.
PART NO.
PART NAME
QTY
CAUTION
1
1224100-037000 0 grade flame retardant cable tie (black 3.6×295)
3
2
1184200-030000 ZT310-R sub-mud board adapter cable (L=2000)
1
3
1251100-101000 Non-standard bolt M6×12 (304 stainless steel)
2
4
1274100-095000 ZT250-S Flameout switch wire fixing bracket
2
5
1250105-143093 GB5789M8×35 (environmental color)
1
6
1250501-007093
GB93φ8 (environmental color)
3
7
1250503-021093
GB97.1φ8 (environmental color)
3
8
1250105-149093 GB5789M8×30 (environmental color)
2
35
～
40N.m
9
1250303-011093 GB6177.1M8 (environmental color)
1
35
～
40N.m
Fig.1 Rear wheel, swinging
arm assembly
PROCEDURE:
●
Rear auxiliary mud board assembly
Find the 3 plugs at the transfer plug and unplug the shown three plugs.
Cut or use a tool to pick up the strap
⑴
head stop.
Remove bolt
⑶，
remove support
⑷
.
After fixing the nut
⑼
with the plum wrench, then remove the bolt
⑸
with the sleeve, remove the cushion
⑹
,
the flat pad
⑺
and the nut
⑼
.
After supporting the rear mud plate assembly, remove the snails
⑸
and
⑻
with the sleeve, remove the elastic
pad
⑹
and the flat pad
⑺
, respectively.
Remove the auxiliary mud plate transfer line and the rear mud board assembly.
CAUTION:
●
The seat cushion, left side cover, etc. must be removed in advance.
●
Do not pull the cable hard when removing the sub-mud switch.
●
When reassembling, make sure that the torque of the three M8 bolts reaches 35N.m, and you need to apply the
thread fastening glue first. Before tightening the bolts, check that there is any pressure on the wires to prevent
short circuits when tightening the bolts.
●
From 12 November 2019 "a" bolt length changed from 35 to 30.
Rear auxiliary mud plate component 1
