3、INTAKE SYSTEM COMPONENT
23
CHK
ADJ
NO.
PART NO.
PART NAME
QTY
CAUTION
1
1250306-006097 GB923 M10×1.25×18
（
Chroming
）
1
2
1251500-007091
Non-standard flat mat φ10.5×φ24×2
（
White zinc
）
1
3
1251100-101000 Non-standard bolt M6×12
（
304stainless steel
）
1
4
1274100-057095
flanging bushing φ6.2×φ8.5×3.5
＋
φ14×1.5
2
5
1244100-052000 buffer rubber of flanging bushing
（
φ8.5×φ14×1
）
3
7
1251100-102000 Non-standard bolt M6×16
（
304stainless steel
）
3
8
1224200-110000 ZT310-V rear inner mud plate
1
A
B
C
D
PROCEDURE:
●
Side cover
Refer to the method of removing the right cover on the previous page, remove the left and right covers.
●
Left rear shock absorption
Remove the nut
⑴
with the sleeve
，
then remove the flat mat
⑵
.
●
Back inner mud board
Remove the bolts
⑶
and
⑺
on the left side, remove the bushings
⑷
and
⑹
, and then remove the cushion
rubber
⑸
.
Remove the wheel speed sensor wire and the rear brake caliper tubing from the tubing clamp and remove the
two bolts
⑺
shown.
Remove the bolt
⑺
on the inside of the front and remove the bushing
⑷
before removing the cushion rubber
⑸
.
Pull the left rear shock absorbing head outward and remove the rear inner mud plate
⑻
.
CAUTION:
●
Do not pull out the stud end face completely when pulling the rear shock absorber head.
●
Pay attention to the force when pulling out the wheel speed sensor line and the oil pipe.
●
The bolt in the middle of the front right side (Figure C) cannot be removed.
Fig.9 INDUCTION
SYSTEM COMPONENT
Replace the air filter element (Bosch) 1
6
1251700-059093
flanging bushingφ6.4×φ9×8
＋
φ18×2
（
environmental
color
）
1
