1、FRAME COMPONENT
12
CHK
ADJ
NO.
PART NO.
PART NAME
QTY
CAUTION
1
1251100-101000 Non-standard bolt M6×12 (304 stainless steel)
4
2
1184200-137000 ZT310 PKE Controller
（
bracelet edition)
1
3
1274200-271000 ZT310
－
V1 PKE holder
1
4
1244200-132000 ZT310PKE rubber sleeve
1
PROCEDURE:
●
PKE Controller
Unplug the PKE plug, use a No. 4 allen wrench to remove the two bolts
⑴
to remove the PKE assembly
⑵
and ZT310PKE rubber sleeve
⑷
;
●
PKE bracket
Use a No. 4 allen wrench to remove two bolts (1) to remove the PKE bracket (3);
●
Fuse
Remove the fuse
①、②
, check whether it is blown, if it is blown, replace the fuse of the same specification.
The band version of the PKE assembly uses 2 small 15A fuses.
●
Charging
Unplug the fuse
①
, turn on the dustproof glue
③
of the PKE charging port, and plug the charger into the
charging port for charging. If the charger indicator shows red, it means charging, and green means fully charged.
CAUTION
：
●
When inserting and pulling out the fuse, please pay attention to the vertical alignment before disassembly, and
it is strictly prohibited to bend. A qualified fuse should be used.
●
PKE cables need to be protected. Non-professionals are strictly prohibited to disassemble the PKE system
components, otherwise it may cause permanent damage.
●
Please refer to the driver's manual for PKE operating instructions.
●
Be careful not to overcharge the charging time. Please refer to the manual for details on battery usage and
maintenance.
●
The button battery model used in the band version: CR1225.
Fig.6 FRAME&ELECTRONIC
PARTS COMPONENT
PKE component
（
Bosch/colloid battery
）
