© 2016 ZOLL Data Systems, Inc. All rights reserved.
59
CONFIDENTIAL TRADE SECRETS – DO NOT DISCLOSE.
Z
O
L
L
D
o
c
u
m
e
n
t
a
t
i
o
n
5.
Testing Calibration Results
At this point, both speed and RPM are calibrated and the vehicle should be taken on a test drive to confirm
that the RS4000 is detecting speed and RPM values correctly. The vehicle operator and Diagnostic Viewer
operator can make sure speed and RPM match between the vehicle and RS4000 by comparing values on
the vehicle speedometer to values displayed in Diagnostic Viewer’s SxS tab. Note that Diagnostic Viewer
always displays speed values in kilometers per hour so the SxS values should be compared against the
metric speedometer readings, if available.
6.
Saving Calibration Results
Once the calibration results have been tested and found to be acceptable, the settings must be saved. Save
the settings by clicking the fourth icon from the left on the Diagnostic Viewer toolbar. See the figure below
for an example screenshot.
