© 2016 ZOLL Data Systems, Inc. All rights reserved.
16
CONFIDENTIAL TRADE SECRETS – DO NOT DISCLOSE.
Z
O
L
L
D
o
c
u
m
e
n
t
a
t
i
o
n
STEP 4: PREPARE HARNESSES FOR LOOMING AND APPROPRIATE ROUTING
Locate and identify the connection points for the seatbelt, brakes, reverse, parking brake, turn signals, lights and
siren, and camera controller (if used). Prepare the wire harnesses by adding protective loom and routing to the
connection points on the driver’s side dash and to other areas of the vehicle. See Appendix C and Form 3 Build
Sheet for wiring assignments and possible connection locations.
Make sure the wires do not interfere with moving parts, contact sharp edges and are long enough to reach the
wire connection point without stress.
RS-4101 Power/Audio Harness
Typical Routing -Separate the speaker wires which will route aft to above and behind the driver’s seat.
See Page 42 and Form 3 Build Sheet for wiring assignments.
NOTE:
Unused wires may be cut off to approximately 12-18” (30-45cm) and taped off individually for future use
and to facilitate an orderly build of the remaining wires into one harness.
NOTE:
Locations for battery power, ground, ignition, and speaker connections made to this harness vary by
vehicle. Refer to your Sample Install Form (Form 3) or applicable OEM schematic diagram.
