Ziton ZP2-AF2-P, Руководство по установке

Страница: 93 / 176

Chapter 3: Configuration and commissioning
ZP2-A Series Installation Manual 87
Expansion board configuration
Select Expansion boards to add an installed expansion board to the control panel
configuration.
Note: If the installed expansion board firmware is not compatible with the control
panel, a warning message is displayed.
The available expansion boards are shown in the table below.
Table 34: Available expansion boards
Option
Description
LB Loop board [1]
NB Network board [2]
ZIC Zone LED indicator board
PIB Peripherals interface board
DACT DACT board
[1] Use only ZP2-A-LB loop boards (older loop boards are not compatible for use with ZP2-A
control panels).
[2] By default repeater panels have the network board configured as installed.
To add an expansion board:
1. Select Panel setup from the Main menu.
2. Select Expansion boards.
3. Select the expansion board that you want to add, and then select YES.
4. Press F4 (Enter), and then press F1 (Back).
5. Press F1 (Save), F3 (Apply), F4 (Discard), or F2 (Exit).
Remember to apply saved settings from the Main menu.
If an installed expansion board is not detected by the control panel, a system
fault is indicated.