Ziton ZP2-AF2-P, Руководство по установке

Страница: 80 / 176

Chapter 3: Configuration and commissioning
74 ZP2-A Series Installation Manual
Command filter
Select Command filter to configure the types of commands sent to the fire
network in control panels with the corresponding global controls configured.
The commands that can be configured are shown in the table below.
Table 29: Command filter configuration options
Command
Description
RST Reset
PnSilen Panel silence
SND Sounder start/stop
SND_DLY Sounder delay (enable delay or cancel active delay)
FR Fire routing start/stop
FR_DLY Fire routing delay (enable delay or cancel active delay)
FP Fire protection start/stop
FP_DLY Fire protection delay (enable delay or cancel active delay)
D/N_M Day/night mode change [1]
UKSB UK school bell on
[1] Used to allow control panels within the network to have locally-defined day/night mode
settings. If this setting is not activated, the control panel does not send the day/night mode
change and does not process these commands when received from other control panels in the
fire network.
To change the Command filter settings:
1. Select Panel setup from the Main menu.
2. Select Firenet, and then select Command filter.
A list of available commands that can be configured is displayed.
3. Select all commands to be filtered.
4. Press F4 (Enter), and then press F1 (Back).
5. Press F1 (Save), F3 (Apply), F4 (Discard), or F2 (Exit).
Remember to apply saved settings from the Main menu.