Zimmer Sonido Smart, Инструкция по эксплуатации, Страница: 50 / 173

35
Chapter 5 Operating and examination mode
This chapter mainly describes the process for normal operation of the device, including preparation for an examination, how to cre-
ate and optimise the image, how to add comments and body markers, and so on.
5.1
Preparing the system for use
5.1.1
Device inspection
(1)
The device is placed on a stable surface;
(2)
The mains voltage is AC 100-250 V, 50 Hz-60 Hz;
(3)
The cable is connected and earthed properly and firmly, and the adapter rests properly on the device;
(4)
The probe is connected and fixed in place.
5.1.2
Turning on
Press for 1 second to start the machine, wait until the system appears on the user interface, and activate the
probe slot in B mode.
5.2
Selecting the examination mode
5.2.1
Probe detection
By default, the system automatically detects the current probe type. When the probe is being inserted, press
to change the probe.
CAUTION:
Only connect or disconnect the probe when the system is stationary in order to ensure stability and extend
the operational life of the probe.
5.2.2
Mode selection
In the probe selection interface, the page for the probe and clinical application is displayed; you can choose the neces-
sary probe and examination part, then press to switch to the default B mode and start the scan.
NOTE:
Each probe has been individually factory-preset. Refer to the section on presets for detailed steps on pre-
setting the clinical application.