MAXinBOX FC 0-10V VALVE
http://www.zennio.com
Technical Support:
http://zennioenglish.zendesk.com
11
“
[AOx] Output Value (Control)
”: this object is provided to receive
percentage values from the KNX bus, making the device generate a voltage
output between 0 VDC and 10 VDC (proportional to the percentage value).
“
[AOx] Output Value (Status)
”: status object that shows, in terms of
percentage, the current value of the analogue output signal. This object is
automatically sent to the bus after receiving a new voltage setpoint, and when
the output status changes due to a lock order.
The following parameters can be configured from the corresponding tab:
Figure 5
0-10V Analogue Output X – Configuration (detail).
Enable Lock by Object
: when this checkbox is marked, the one-bit object
“
[AOx] Lock
” turns visible, as well as one more parameter:
Lock Action
: sets the particular state (“No Change” / “On” / “Off”) the
output will adopt upon the reception of the value “1” through the “
[AOx]
Lock
” object. If set to “On”, the desired
Output Value
needs to be
configured, in terms of percentage.
Note
:
while an output is locked, further voltage setpoints are ignored (the
device will respond with the current status of the output).
Initialization
: brings the option to set the output to a particular state at the
start-up of the actuator.
