DOC-USR-0151-01
___________________________________________________________________________________________
Z3 Technology, LLC
♦
100 N 8
th
ST, STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
39
7.0
RUNNING THE DECODER
The DME-05 can also be configured as a video decoder. To see an example of this follow the steps below.
7.1
Set to Decoder Mode
(1)
Connect an Ethernet cable from “Ethernet” on the back of the unit to a switch, router or other DHCP
server on the same network as your Windows PC. You will use this PC to control the DME-05 and to
decode the output stream.
(2)
Connect the AC power supply. It will take 45-60 seconds to boot.
(3)
Follow the steps in Sections 6.3 to access the user interface.
(4)
Change “Operating Mode” in the lower right corner of any tab to “Decoder” using the dropdown
menu.
See the following Sections 7.2, 7.3 and 7.4 to set the decoder unit to accept a variety of encoded
content formats. See Section 7.5 to output decoded content via HDMI and Section 7.6 to output decoded
content via SDI.
Figure 37 DME-05 Rear Panel Decode Setup Connections
(1) Connect
Ethernet
(2) Connect Power
Figure 38 Changing to Decoder Mode
Change to
“Decoder”
