YSI MultiLab 4010-1W, Руководство по эксплуатации

Страница: 67 / 114

MultiLab 4010-1W Settings
ba76141e07 08/2018
67
9.2 ORP measurement settings
9.2.1 Settings for ORP measurements
The settings are made in the menu for measuring settings of the ORP measure-
ment. To open the settings, display the required measured parameter in the
measured value display and press the
<ENTER>
key. After completing the
settings, switch to the measured value display with
<M>
.
Default settings are printed in bold .
9.3 D.O. measurement settings
9.3.1 Settings for D.O. sensors
(menu for measurement and calibration settings)
Settings The settings are available in the menu for measurement and calibration set-
tings. To open the settings, display the required measured parameter in the
measured value display and press the
<ENTER>
key. After completing the
settings, switch to the measured value display with
<M>
.
The possible settings are individually displayed for each sensor. Below, the set-
ting menu is shown with all settings for all IDS-D.O. sensors.
Default settings are printed in bold .
3. Confirm the setting with
<ENTER>
.
4. Quit the menu with
<M>
.
Menu item Possible setting Explanation
mV resolution 0.1
1
Resolution of the mV display
Reset - Resets all sensor settings to the
delivery condition (see section
9.6.1 R
ESETTING THE MEASUREMENT
SETTINGS
, page 75).
Menu item Possible
setting Explanation
Calibration /
Calibration record
- Displays the calibration record of
the last calibration.
Calibration /
Calibration data
storage
/ Display
- Displays the last calibration records
(max. 10)
Calibration /
Calibration data
storage
/ Output to
RS232/USB
- Outputs the calibration data stor-
age to the interface