2. Transportation, Storage and Installation
2-18
TI 33Q01J10-01E
F020423.ai
e
h
Hooked part (1place)
Bottom plate of desk
M3 screws
Bottom plate
a
b
c
a
d
b
c
i g
h f
Figure Joining Parts and Tools for Interconnecting YPCKITs Side-by-Side
Referring to the figure above, follow the procedure described below to connect the HIS with bolts.
When tightening bolts e, f, and g, make sure that console type HIS are aligned.
1. Using a hexagonal wrench, loosen hex socket head bolts d (4 bolts) securing the main body
and the channel base to each other.
2. Remove the bottom place of desk, and tighten the tapered bolt screws e using an L-wrench
j. To remove the bottom plate of the desk, remove the nine M3 screws, pull the front side of
the bottom plate down and pull the plate toward you. You can then release the hooked part
of the plate and remove the operator keyboard from the bottom area.
3. Open front and rear doors, and tighten tapered bolt screws f with L-wrench k.
4. Tighten bolt screws g with an L-wrench j.
5. Confirm that surfaces of the side-by-side HIS are aligned, then use a hex wrench to join
main body to the channel base using hex bolts. If there’s a gap between main body and
channel base, insert liner.
6. Replace the removed plates and bottom plates in their original positions.
SEE
ALSO
For details on the related tools and parts for joining console-type HIS’s side-by-side, refer to “Tools and Parts
Required for Joining Console Type HIS side by side.”
Sep. 30, 2008-00
